Can't find the right forum, then post your general surf-related remarks here!
Moderators: jimmy, collnarra, PeepeelaPew, Butts, beach_defender, Shari, Forum Moderators
-
marcus
- Owl status
- Posts: 4363
- Joined: Sat Jan 10, 2004 1:56 pm
- Location: s island
Post
by marcus » Fri Dec 21, 2007 12:13 pm
Can anyone recommend a good car cover or cooling system to stop your spare boards getting hot and wax melting inside your car, either while parked at work or at the beach?
I have a couple of ideas:
1. A solar powered fan, possibly incorporating a Peltier device to cool the inside of the car. (Not sure if it will work, thermodynamics, efficiency etc).
A Peltier device is used in car cooler/warmers; you put current in, one side gets hot, and the other gets cold.
2. A board bag type material that covers the roof and windows, with vents.
3. park under a tree.
If anyone has any ideas id be glad to hear them, and if you want to borrow one of mine, go ahead. (10% inventors fee
![rofl :D](./images/smilies/rolf.gif)
)
-
crooked
- Local
- Posts: 471
- Joined: Thu Dec 15, 2005 4:55 pm
Post
by crooked » Fri Dec 21, 2007 12:47 pm
Need a lockable under-car rack.
A few simple welds on the bottom of ya car to set up the racks and viola!
from the rear of your car push the nose of your board into the front rack and then lock the tail of ya board with the rear rack.
Boards would get heaps more ventilation than in the car and would not be exposed to daylight or radiant heat. And it would be safe coz you lock it up with a big fuck off padlock (whereas in a car all you need to do is break the windows).
You could prolly only fit one or two boards under a normal car though, and you would have to engineer the racks well so that they wouldn't hinder normal driving.
DONT DRIVE OFF WITH YA BOARD IN THE UNDER-CAR RACK !!!
-
wanto
- barnacle
- Posts: 2413
- Joined: Sun May 06, 2007 9:25 am
Post
by wanto » Fri Dec 21, 2007 1:11 pm
put a towel over the wax and leave the windows down.
-
barstardos
- charger
- Posts: 905
- Joined: Tue Jan 20, 2004 2:47 pm
- Location: Queenscliff
Post
by barstardos » Fri Dec 21, 2007 1:44 pm
Leave car at home, walk to the beach
-
Shaunm
- Snowy McAllister
- Posts: 9400
- Joined: Tue Aug 17, 2004 2:30 pm
- Location: Manly Lagoon
Post
by Shaunm » Fri Dec 21, 2007 1:57 pm
I agree with Barsti.
However I got a sun shield thing from Kmart fo $9 which covers windshield and 2 front windows, so I figure if that makes a reasonable difference, then 2 should do better & keep wax in tiny cooler bag
-
GD
- newbie
- Posts: 21
- Joined: Fri Feb 06, 2004 11:01 am
Post
by GD » Fri Dec 21, 2007 2:10 pm
shaun
if the wax is in a cooler bag then when you get to the beach it will be cooler than the wax on your board. This means when you wax up the board it takes the softer stuff off or just smears it instead of the other way round. Surely this happens to a few people. I have started putting the wax in the board bag now because of this. Same temp.
-
Shaunm
- Snowy McAllister
- Posts: 9400
- Joined: Tue Aug 17, 2004 2:30 pm
- Location: Manly Lagoon
Post
by Shaunm » Fri Dec 21, 2007 2:23 pm
I must of misread, I meant at the beach as it would be hard to drive with sun protectors on front and back
![Wink :wink:](./images/smilies/icon_wink.gif)
-
Kunji
- Huey's Right Hand
- Posts: 31251
- Joined: Tue Mar 28, 2006 11:10 am
- Location: 40 - nil
Post
by Kunji » Fri Dec 21, 2007 2:32 pm
Just quit surfing and start up \"wake skating\", the worlds most hardcore sport. Total start up cost = $59,000.
-
ric_vidal
- Snowy McAllister
- Posts: 6124
- Joined: Wed Apr 28, 2004 4:34 pm
Post
by ric_vidal » Fri Dec 21, 2007 2:35 pm
marcus wrote:
3. park under a tree.
Might be able to help you there Marcus.
The solar fan has been done... I think (well sometimes).
-
Shaunm
- Snowy McAllister
- Posts: 9400
- Joined: Tue Aug 17, 2004 2:30 pm
- Location: Manly Lagoon
Post
by Shaunm » Fri Dec 21, 2007 2:38 pm
True Ric, but make some models a lot easier to break into
-
marcus
- Owl status
- Posts: 4363
- Joined: Sat Jan 10, 2004 1:56 pm
- Location: s island
Post
by marcus » Fri Dec 21, 2007 7:08 pm
cheers guys
when i was talking about the wax melting, i was refering to the wax on the board.
also my little brother once had my first ever board in his car, he was into riding a single fin at the time.
he left the car in the sun, well his mechanic did. and the whole fibreglass and foam rail down one side warped and collapsed leaving a one inch deep channel down the rail.
im trying to avoid that sort of stuff.
-
marcus
- Owl status
- Posts: 4363
- Joined: Sat Jan 10, 2004 1:56 pm
- Location: s island
Post
by marcus » Fri Dec 21, 2007 7:10 pm
barstardos wrote:Leave car at home, walk to the beach
35 min drive to newcastle, 3 hours to cronulla
-
Nappy
- Local
- Posts: 714
- Joined: Wed Aug 03, 2005 7:14 pm
- Location: In the pocket or over sections.
Post
by Nappy » Fri Dec 21, 2007 9:06 pm
Put a towel on your surfboard...Seriously next ppl will be asking how to wipe there ass...
-
--++sunstroke++--
- Owl status
- Posts: 3946
- Joined: Thu Sep 14, 2006 8:49 pm
- Location: the office
Post
by --++sunstroke++-- » Sat Dec 22, 2007 11:41 am
salty wrote:I don't usually leave my board in the back of the ute (in the sun) at work. I'll take it inside. But, if I know I have to park in the sun all day somewhere, I'll wrap a wet towel around it in the AM and chuck it my board bag... works a treat.
Nail, hammer
![Idea :idea:](./images/smilies/icon_idea.gif)
-
bc
- charger
- Posts: 780
- Joined: Mon Jul 19, 2004 12:41 pm
- Location: Redfern Shores
Post
by bc » Sat Dec 22, 2007 12:28 pm
If you can screen the windows on the outside rather than the inside its more efficient.
(tuck the reflectors into the doors so someone won't flog it)
There was a solar fan a while ago, that ran along the top of the window. jamming in when the window was wound up, meaning no security problems.
You can do the trick of using tropical wax as a base, with a top layer of regular wax - this will mean its not going to melt and slide off the board.
-
Beanpole
- That's Not Believable
- Posts: 69674
- Joined: Mon Apr 25, 2005 8:21 am
- Location: Button Factory
Post
by Beanpole » Sat Dec 22, 2007 1:28 pm
marcus wrote:barstardos wrote:Leave car at home, walk to the beach
35 min drive to newcastle, 3 hours to cronulla
Note-there are surfbreaks beween newcastle and cronulla.
Wasn't there a thread about in car versus on car surfboards and heat transference a while ago
![Question :?:](./images/smilies/icon_question.gif)
-
rex
- regular
- Posts: 252
- Joined: Thu Jun 21, 2007 5:45 pm
- Location: Nulla
Post
by rex » Sat Dec 22, 2007 1:55 pm
if you have the money fork out for some window tints that drastically reduces the inside temp and buy some window sun shields they work well
-
tube5
- Grommet
- Posts: 43
- Joined: Thu Jan 22, 2004 11:17 am
Post
by tube5 » Sat Dec 22, 2007 3:44 pm
I leave my boards in the car all day...every day while at work.
Best investment is a good quality 10mm tight fitting board cover to minimise any air gaps inside the cover that can heat up(I use FCS explorer covers).....& dry your board off before placing it in the cover to stop the "sauna effect". If it's gonna be a really hot day I'll try & park in the shade....if not I leave all the windows down approx. 2cm , lay a white towel over the board & use reflective windscreen shades. It helps if you have a white car. Been doing this for years & haven't cooked a board yet....never really had much of a problem with melting wax either.
Who is online
Users browsing this forum: No registered users and 123 guests