Discuss shaping and repairing techniques here.
2 posts • Page 1 of 1
- Posts: 2315
- Joined: Sat Jan 10, 2009 11:26 am
- Location: home is where the heart is.
Hey beer fan, I’m not sure mate. I’m tossing up wether to get a surblank or a midget red blank. I like the density of the red blank, will need a six three to get a 5 foot belly that I’m after. My sims will be 18 tail, 16 blunt nose, around 22 wide. 2 inch at nose and 1 inch at tail. Not sure where center will be but thinking of pushing it forward. I’m keen to do two tri fin bonzers. 4 inch centre in a box and two small side bits with a 4 degree cant. One board will have mellow bonzer conclaves with the 4 degree fins and one will have deeper conclaves with a higher cant, just cause I can. Not sure when this will happen as my shed is a work in progress. I need a new tin roof. Will have one over head double light and one side will have 8 foot of side lights. Will use the shed for all stages and ame thinking of putting an inch of sand on the floor. Nothing like bare foot shaping. I reckon I will be ready to start in the summer
no, Im not a surfer, Im just a garbage man".
Who is online
Users browsing this forum: No registered users and 4 guests