Belly board

Discuss shaping and repairing techniques here.

Moderators: Butts, Shari, collnarra

Post Reply
Beerfan
Snowy McAllister
Posts: 8633
Joined: Mon Jan 30, 2006 3:09 pm

Belly board

Post by Beerfan » Sat Jan 20, 2018 9:19 am

Where'd the thread go?
Image

Could you use something like this? $160 before shipping
we are the angry mob
We read the papers everyday
We like who we like, we hate who we hate
But we're also easily swayed

diggerdickson
barnacle
Posts: 2315
Joined: Sat Jan 10, 2009 11:26 am
Location: home is where the heart is.

Re: Belly board

Post by diggerdickson » Sun Jul 15, 2018 2:09 pm

Hey beer fan, I’m not sure mate. I’m tossing up wether to get a surblank or a midget red blank. I like the density of the red blank, will need a six three to get a 5 foot belly that I’m after. My sims will be 18 tail, 16 blunt nose, around 22 wide. 2 inch at nose and 1 inch at tail. Not sure where center will be but thinking of pushing it forward. I’m keen to do two tri fin bonzers. 4 inch centre in a box and two small side bits with a 4 degree cant. One board will have mellow bonzer conclaves with the 4 degree fins and one will have deeper conclaves with a higher cant, just cause I can. Not sure when this will happen as my shed is a work in progress. I need a new tin roof. Will have one over head double light and one side will have 8 foot of side lights. Will use the shed for all stages and ame thinking of putting an inch of sand on the floor. Nothing like bare foot shaping. I reckon I will be ready to start in the summer
no, Im not a surfer, Im just a garbage man".

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests