Non-slip surface

Discuss shaping and repairing techniques here.

Moderators: Shari, collnarra, Butts

Post Reply
User avatar
Rustt
charger
Posts: 955
Joined: Wed Feb 23, 2011 6:23 pm
Location: Southwest Victoria

Non-slip surface

Post by Rustt » Sun Jun 14, 2015 7:55 am

I'm fixing a crease in my SUP, it has a non-slip surface pretty sure it is sugar. How do you do it? Mix it in with the final coat or sprinkle it on top?

User avatar
foamy
Harry the Hat
Posts: 3261
Joined: Thu May 08, 2014 6:46 pm

Re: Non-slip surface

Post by foamy » Sun Jun 14, 2015 9:47 am

Caster sugar has been a popular low cost option for wind surfers, they say it works well, though I make no recommendation as I have never done this, and I am sadly very basic on the handy scale.

I reckon they are easier options, but with sugar
"Tape around the area you want to regrip then using a foam roller apply a thin coat of epoxy resin, then sprinkle over it with caster sugar and lightly roll it out for an even finish. Once it has dried hose the board down to dissolve the sugar. It is a good grip that wont make your ankles bleed."

Here's some not great photos of the process.
http://www.seabreeze.com.au/forums/Wind ... -Tutorial/

User avatar
Rustt
charger
Posts: 955
Joined: Wed Feb 23, 2011 6:23 pm
Location: Southwest Victoria

Re: Non-slip surface

Post by Rustt » Sun Jun 14, 2015 12:37 pm

Thanks Foamy, I had a search of seabreeze but could not find anything, good link:-)

User avatar
Fuschia
Duke Status
Posts: 17935
Joined: Mon Feb 23, 2004 3:11 pm
Location: Any Point Break

Re: Non-slip surface

Post by Fuschia » Sun Jun 14, 2015 12:40 pm

We used to use sand on the deck of our Quick Cats.
Loofy wrote
"when i lived in Bellevue hill"

lol :-o

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests