Selling 6"2 M80 COIL Industries shaped by Mike Daniel.
Epoxy stringer less construction In real good condition with only some foot dents and minor bumps.
Feels like a P/U underfoot but has that extra load and release. Very durable but light.
Goes well from 1ft grovel to 4ft everyday conditions.
Dims 6"2 - 21x 2/9/16 deep single
Check out some reading below if your not familiar with these boards.
http://www2.swaylocks.com/forums/coil-r ... s?page=420
http://coilsurf.com
http://c.slum.se/[img]
PM me if interested
** fins in pictures not included .
COIL Industries 6"2 For Sale
Moderators: jimmy, collnarra, PeepeelaPew, Butts, Shari, Forum Moderators
COIL Industries 6"2 For Sale
- Attachments
-
- 005.JPG (36.8 KiB) Viewed 3877 times
-
- 003.JPG (78.18 KiB) Viewed 3877 times
-
- 007.JPG (76.35 KiB) Viewed 3877 times
-
- 002.JPG (70.18 KiB) Viewed 3877 times
-
- 006.JPG (72.91 KiB) Viewed 3877 times
Re: COIL Industries 6"2 For Sale
Set up is a little G1000 centre fin and some Shapers SMF-Large in the sides . Plenty of drive and good release for the wide tail.
- steve shearer
- BUTTONMEISTER
- Posts: 45163
- Joined: Mon Oct 13, 2008 8:20 pm
Re: COIL Industries 6"2 For Sale
Why the sale DV8?
I want Nightclub Dwight dead in his grave I want the nice-nice up in blazes
Re: COIL Industries 6"2 For Sale
DVeight - where did you acquire your Coil?
Just asking as a matter of interest as one of the guys on a recent trip had a couple and he was loving them. As you said, they look & feel pretty durable, but the guy riding them was a veritable jockey so can't imagine he'd make an impression (compression) on anything.
Good luck with the selling mate.
Just asking as a matter of interest as one of the guys on a recent trip had a couple and he was loving them. As you said, they look & feel pretty durable, but the guy riding them was a veritable jockey so can't imagine he'd make an impression (compression) on anything.
Good luck with the selling mate.
Re: COIL Industries 6"2 For Sale
Steve , nothing sinister mate, just selling it because I'm about to be made redundant . I have two grovel boards and its the oldest.
Ric , I got them sent over from the States , not a cheap exercise with customs charges but get a few
and it works out O.K.
Ric , I got them sent over from the States , not a cheap exercise with customs charges but get a few
and it works out O.K.
- steve shearer
- BUTTONMEISTER
- Posts: 45163
- Joined: Mon Oct 13, 2008 8:20 pm
Re: COIL Industries 6"2 For Sale
Sorry, wasn't implying anything ....was just curious.
Always wanted to eyeball and tyre kick a Coil.
Always wanted to eyeball and tyre kick a Coil.
I want Nightclub Dwight dead in his grave I want the nice-nice up in blazes
Who is online
Users browsing this forum: No registered users and 54 guests